When beads don’t stick properly or if bead designs break:
• Too much water will not join the beads together.  Remember to only lightly spray the beads. 
• If design did not stick together properly, wait until completely dry and lightly spray again. 
• You must lightly spray all the Bindeez beads with the water spray until there is water in-between each bead.
• When beads are completely dry, try spraying the reverse side of the design to make it even stronger.
• Some areas where only one bead joins may need addition sprays of water to make the beads join together. Remember to do this when design is dry.

When the back of a bead design is not glossy:
• Spray some more water on the back and leave to dry.

If beads stick to your fingers:
• Wash and dry your hands well if beads start sticking to your hands. Moisture will make the beads sticky.
• Keep loose beads away from water spraying area – if they get wet wait until dry and move them. 

If designs begin to bend while drying:
• Place your Bindeez design underneath a heavy book to dry design flat.

If you have having trouble making a 3D design:
• When making 3D elements, make parts separately and wait for them to dry before joining them together.

If beads get stuck on the tray:
• Use a thin piece of card and push between the beads and the tray to remove beads.

If the bead removal tool stops sticking to the beads:
• Lightly spray the end of the Bead removal tray with water to make the end sticky again.